OPTO FlashCable for use with GagePorts & SPC Software A FlashCable when used with either VisualSPC or Proficy ShopFloor SPC will be autodected by the GagePort, and then the FlashCable information will be automatically entered into the gage document in either of these 2 software packages. This means the Gage Document will automatically know what port the FlashCable is plugged in to, and if you have stored any calibration date information onto the FlashCable, that information will also be updated into the gage document. The OPTO gage interface connector is a popular type of connector that is used by a variety of different gage manufacturers for their gages. We have listed below an example of the gages that this cable will work with... Fowler Sylvac Ultra-Cal, Euro-Cal (such as Mark II, Mark III, Mark IV, Mark V) Starrett 797 Electronic Digital Caliper Starrett 782 Micrometer Starrett 781 Accubore Mahr Federal 25ES / 27ES / 31ES / 32 ES MarCal MultiMar Caliper Mahr Federal M 814 Digimar Mahr Federal 106 ES MarTool Protractor Mahr Federal 1082 Bowers Micrometer Brown & Sharpe Micrometer Euro-Cal III Caliper Mark II Bore Gage S_Cal Calipers Sylvac Calipers Syvac Gages with Paddle Sylvac Series 213 indicators Digital Ultra-Height Gage Holematic Mark II XT Holematic and HoleMikes MiniVertical Series II Starrett 781 Accubore Starrett 782 Micromerter Starrett 797 Caliper Mahr 25 ES / 27 ES / 31 ES / 32 ES Mahr 106 ES Mahr 1082 Mahr Digimar M 814 Multimar 25 ES MarTool 106 ES